FORD ESCAPE 2012 HOW TO
FORD ESCAPE 2012 CODE
FORD ESCAPE 2012 PLUS

The repair is expensive if out of warranty. Symptoms include a lack of steering assist, warning light and the steering wheel shaking by itself. The part that typically fails is the EPAS Torque Sensor. Replacing the transmission with a used unit will cost up to $2,300.Ī number of owners mentioned problems with electric power steering even after the recall 14S05 has been done. There are many reports of transmission failures at higher mileage, especially in 2008, 2009 models. Ford also issued several recalls that you also can check at the NHTSA website. Throttle body issues are not uncommon too, but according to many sources, Ford has extended the throttle body warranty coverage to 10 years or 150,000 miles. Failed blend door actuators need to be replaced. Cleaning the sensor usually helps.īlend door actuators could make a buzzing noise in the 2008-2009 Ford Escape hybrid.

FORD ESCAPE 2012 CODE

The Check Engine light with the code P0171 could be caused by a contaminated MAF sensor. The repair kit is available from Ford dealers. The repair involves replacing the seal, inner CV-joint housing and possible axle bushing. Symptoms include dropped transmission fluid level and fluid leak on the driveway, in the left front area. The switch is also inexpensive and is easy to replace.Īdvertisement Leaking driver's transaxle seal: Many owners mention the leaking left axle shaft seal The release switch is the button located under the liftgate chrome bezel that you press to open the liftgate or the rear glass. See these YouTube videos for more info.Ĭorrosion at the liftgate release switch can cause the rear glass or the liftgate not to open from the outside. A pair of aftermarket hinges costs from $30 to $70 the replacement is not very expensive. If you see the signs of corrosion around the hinges, have them checked, as a bad hinge might separate creating a safety hazard. This thread describes the DIY repair.Ĭorroded liftgate glass hinges: The hinges that hold the liftgate glass can also corrode in the Rust Belt.

FORD ESCAPE 2012 PLUS

It's an easy and inexpensive repair: 0.5 hours of labor for one front link plus the part. The blower motor resistor is located on top of the HVAC duct behind the glove box and is easy to replace.įront sway bar links go bad often causing a knocking noise in the front end when driving slowly over small bumps. The part costs from $30 to $60 aftermarket parts are cheaper. Watch these videos.īlower motor resistor: If your A/C blower motor works only in 3-rd and 4-th speed, it's very likely that the blower motor resistor has failed.

If a bad purge valve is confirmed, it's easy to replace. The EVAP system must be tested for leaks and the purge valve must be checked for not holding the pressure. Here is a good video explaining the repair.įailed Purge Valve: The code P0456 and/or P0455 could be caused by a bad purge valve/solenoid. Your mechanic may charge you about 2.2 hours of labor plus the part for the repair. The part is not too expensive, but takes some work to replace. Worn ignition lock module: When one of the parts in the ignition lock module is worn out, it may cause a no-crank no-start condition or the vehicle may start after wiggling and pushing in the ignition key.

Signs of automatic transmission problems.

FORD ESCAPE 2012 HOW TO

How to check the engine when buying a used car.How to get the best deal on a used car?.Buying a Used Car: 10 Common Mistakes to Avoid.

Ford escape 2012